Removal And Installation

WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery terminal.
Remove the crash pad lower panel.
(Refer to Body (Interior and Exterior) - "CRASH PAD LOWER PANEL ")
Disconnect the brake switch connector (A) and wiring fastener (B).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the snap pin (A) and clevis pin (B).

Courtesy of KIA MOTORS AMERICA, INC.
NOTE:
- Before installing the pin, apply the grease to the joint pin.
- Use a new snap pin whenever installing.
Loosen the mounting nuts (A).
Tightening torque:

16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the brake pedal assembly (A).

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.