LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Body Side Molding) >> Tailgate Garnish >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Put on gloves to prevent hand injuries.
NOTE:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Take care not to scratch the body surface.
  1. Disconnect the negative battery terminal.
  2. Remove the tailgate trim.

    (Refer to Body - "TAILGATE TRIM ")

  3. Remove the rear combination lamp (A).
    1. Disconnect the RVM & Tailgate open switch connector (A).
      G13481984Courtesy of KIA MOTORS AMERICA, INC.
    2. Disconnect the rear combination lamp connector (A) after loosening the nuts.

      [LH] 

      G13481985Courtesy of KIA MOTORS AMERICA, INC.

      [RH] 

      G13481986Courtesy of KIA MOTORS AMERICA, INC.

      [Center] 

      G13481987Courtesy of KIA MOTORS AMERICA, INC.
    3. Remove the rear combination lamp assembly (A).
      G13481988Courtesy of KIA MOTORS AMERICA, INC.
    4. Remove the rear combination lamp main wiring packing (A).
      G13481989Courtesy of KIA MOTORS AMERICA, INC.
  4. To install, reinstall in reverse order of removal procedure.

    Information 

    • Make sure the connector is connected properly.
    • Replace any damaged clips (or pin-type retainers).
scientia non olet · About LEMON Manuals