Removal And Installation

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B).
Tightening Torque:

9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.

NOTE:

When installing the oil pressure switch, apply seal lock to the thread.

Seal lock: THREEBOND 2403

Thickness: 0.2 - 0.4 mm (0.008 - 0.016 in.)

Courtesy of HYUNDAI MOTOR AMERICA