LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Cylinder Head Assembly - 1.6L) >> Cylinder Head >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When removing the MLA, valve and valve spring check the location of each component so that it can be remounted on its original place.
  • Do not remove the cylinder head, when working on the MLA, retainer lock, retainer, valve spring and valve stem seal.
  1. Remove the MLAs (A).
    CAUTION:
    • When removing MLAs, mark all the MLAs for their rearrangement.
    G12593187Courtesy of HYUNDAI MOTOR AMERICA
  2. Remove the valves.
    1. Using the SST (09222-3K000, 09222-3K100), compress the valve spring and remove the retainer lock.
      G12593188Courtesy of HYUNDAI MOTOR AMERICA
    2. Remove the spring retainer.
    3. Remove the spring retainer.
    4. Remove the valve.
    5. Remove the valve stem seal.
    6. Using a magnetic pickup tool, remove the spring seat.
      CAUTION:
      • Do not reuse the valve stem seals.
scientia non olet · About LEMON Manuals