Repair Procedures: Installation
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse the removal procedure.
- Inject the automatic transaxle oil and inspect the oil level.
(Refer to Automatic Transaxle System - "AUTOMATIC TRANSAXLE FLUID ")
- Clear the diagnostic trouble codes (DTC) using the GDS.
Information
Even though disconnecting the battery negative terminal, the DTCs will not be cleared. So, be sure to clear the DTCs using the GDS.
- In order to prevent start delay and gear shift shock during acceleration and start, perform TCM learning after replacing the solenoid valve.
(Refer to Automatic Transaxle Control System - "REPAIR PROCEDURES ")