Repair Procedures: Removal

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Remove the coupling assembly.
(Refer to 4WD Control System - "DIRECT ELECTRO HYDRAULIC ACTUATOR COUPLING ")

Keep going perpendicular state after remove the coupling assembly.

CAUTION:

Keep going perpendicular state during remove (install) the hydraulic motor (actuators).

Courtesy of HYUNDAI MOTOR AMERICA

Use a tool (A) that allows the auxiliary operator to hold or seat the coupling in a vertical position.

So that the input shaft side (B) is not damaged.

Courtesy of HYUNDAI MOTOR AMERICA

Remove the hydraulic motor (A) after loosening bolts with hex wrench.

Courtesy of HYUNDAI MOTOR AMERICA

NOTE:

Remove the hydraulic motor (actuators) after dropping residual oil as much as possible inside the coupling. (abut 5-10 sec)

Courtesy of HYUNDAI MOTOR AMERICA