Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.

NOTE:

Smear the splines (A) with molybdenum type high pressure grease.

When install the coupling, be careful not to damage the oil seal (B).

Courtesy of HYUNDAI MOTOR AMERICA

After replacing the coupling, reset the 4WD ECU's clutch learning using the GDS tool.
(Refer to 4WD Control System - "REPAIR PROCEDURE ")