LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Anti-Lock Brake System (Abs)) >> Troubleshooting >> When Ignition Key Is Turned On (Engine Off), The ABS Warning Lamp Does Not Light Up >> Inspection Procedures >> Check The Power Source For The ABS Warning Lamp

Check The Power Source For The ABS Warning Lamp

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the instrument cluster connector (M08) and turn the ignition switch ON.
  2. Measure the voltage between terminal (M08) 39 of the cluster harness side connector and body ground.

    Specification:  approximately B+

    G12602765Courtesy of HYUNDAI MOTOR AMERICA
  3. Is voltage within specification?

    YES 

    • Check the CAN circuit resistance for ABS warning lamp.

    NO 

    • Check for blown fuse.
scientia non olet · About LEMON Manuals