LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Timing System - 2.0L) >> Timing Chain >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cylinder head cover.

    (Refer to Cylinder Head Assembly - "CYLINDER HEAD COVER ")

  2. Set No. 1 cylinder to top dead center (TDC) on compression stroke.
    1. Turn the crankshaft damper pulley and align its groove with the timing mark of the timing chain cover.
      G12606435Courtesy of HYUNDAI MOTOR AMERICA
    2. Check that the TDC marks of the intake and exhaust CVVT sprockets are in straight line on the cylinder head surface as displayed in the image. If not, turn the crankshaft by one revolution (360°) more.
      G12606436Courtesy of HYUNDAI MOTOR AMERICA
      NOTE:
      • Do not turn the crankshaft damper pulley counterclockwise.
  3. Remove the timing chain cover & oil pump assembly.

    (Refer to Timing System - "TIMING CHAIN COVER & OIL PUMP ASSEMBLY ")

  4. Remove the timing chain tensioner (A).
    G12606437Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Do not reuse the detached tensioner.
  5. Remove the timing chain tensioner arm (A).
    G12606442Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the timing chain (A).
    G12606443Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the timing chain guide (A).
    G12606444Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals