LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Engine And Transaxle Assembly (R & I) - 2.0L) >> Engine Mounting >> Repair Procedures >> Removal And Installation >> Transaxle Mounting Bracket

Transaxle Mounting Bracket

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air duct and air cleaner assembly.

    (Refer to Intake and Exhaust System - "AIR CLEANER ")

  2. Remove the battery.

    (Refer to Engine Electrical System - "BATTERY ")

  3. Remove the engine control module (ECM).

    (Refer to Engine Control/Fuel System - "ENGINE CONTROL MODULE (ECM) ")

  4. Remove the battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  5. Remove the engine room under cover.

    (Refer to Engine and Transaxle Assembly - "ENGINE ROOM UNDER COVER ")

  6. Install the jack under the transaxle to support it.
  7. Remove the service cover (A).
    G12606377Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the transaxle support bracket mounting bolts (A).

    Tightening Torque: 

    107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)

    G12606378Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the transaxle mounting bracket (A).

    Tightening Torque: 

    49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb-ft)

    G12606379Courtesy of HYUNDAI MOTOR AMERICA
  10. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals