Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

Perform the following:

Adjust shift cable.
Refill engine with engine oil.
Refill transaxle with fluid.
Refill radiator and reservoir tank with engine coolant.
Place heater control knob on "HOT" position.
Bleed air from the cooling system.
- (Refer to Cooling System - "COOLANT ")
Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.
Inspect for fuel leakage.
- After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
- Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.