LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 194 (Propeller Shaft Assembly (4WD)) >> Propeller Shaft >> Repair Procedures >> Inspection >> Propeller Shaft Runout

Propeller Shaft Runout

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a dial indicator with its needle on the center of front propeller shaft or rear propeller shaft.
  2. Turn the propeller shaft slowly and check the runout. Repeat this procedure for the other propeller shaft.

    Propeller Shaft Runout:  0.3 mm (0.012 in.)

    G12605870Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals