Repair Procedures: Replacement: RH
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Take care not to bend or scratch the trim and panels.
- Remove the rear seat back cover [RH].
(Refer to Rear Seat - "REAR SEAT BACK COVER ")
- After loosening the mounting bolt, remove the rear seat latch (A).
- Remove the rear seat latch rod (B) to direction of the arrow.
Tightening Torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
- To install, reverse the removal procedure.