LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Rear Seat Assembly) >> Rear Seat Cushion Cover >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Put on gloves to prevent hand injuries.
NOTE:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the seat assembly.

    (Refer to Rear Seat - "REAR SEAT ASSEMBLY ")

  2. After removing the Velcro tape (A) and hog-ring clips (B) inside the rear seat cushion cover, remove the seat cushion cover (C).

    [Front side] 

    G12605374Courtesy of HYUNDAI MOTOR AMERICA

    [Rear side]

    G12605375Courtesy of HYUNDAI MOTOR AMERICA
  3. To install, reverse removal procedure.

    Information 

    • Make sure that the connectors are connected completely.
    • Replace any damaged clips (or pin-type retainers).
    • To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
    • Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
      G12605376Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals