Battery Reset: Description

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

When reconnecting the battery cable after disconnecting, recharging battery after discharged or installing the memory fuse located on the driver's side panel after removing, be sure to reset systems mentioned in the below table.

In addition, when replacing or reinstalling their fuses after removing, they should be reset according to the below table. Please refer to the below table when servicing.

BATTERY RESET PROCEDURES

System	Resetting
Power window	Whenever the window cannot be properly closed or opened. Whenever the battery is discharged or the related fuse is replaced or reinstalled, reset the power window system according to the procedure below. Turn the ignition switch to the ON position. Push up the power window switch until the window glass is entirely down and then push up continuously for about 1 sec.
Sunroof	Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof system as follows : Turn the ignition key to the ON position and then close the sunroof completely. Release the sunroof control lever. Press and hold the CLOSE button for more than 10 seconds until the sunroof closed and it has moved slightly. Release the sunroof control lever. Press and hold the CLOSE button once again within 3 seconds until the sunroof does as follows; Tilt down → Slide Open → Slide Close Then release the lever. Reset procedure of sunroof system is finished.
Trip computer	When the battery is disconnected and reconnected, the set functions of the trip computer become initialized. So, you need to explain this information to the customer.
Clock	When the battery is disconnected and reconnected, the clock becomes initialized. So, the clock should be reset. (Refer to the owner's manual)
Audio	When the battery is disconnected and reconnected, the customer's radio stations become initialized. So, you need to record the customer's radio stations prior to service, and after service, set the customer's radio stations into the audio.
Heater & Air Conditioner	When the battery is disconnected and reconnected, the heater and A/Con become initialized. So, heater and A/Con should be reset.