LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Front Seat Assembly) >> Front Seat Cushion Cover >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Put on gloves to prevent hand injuries.
NOTE:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the front seat assembly.

    (Refer to Front Seat - "FRONT SEAT ASSEMBLY ")

  2. Remove the front seat shield inner cover.

    (Refer to Front Seat - "FRONT SEAT INNER COVER ")

  3. Remove the front seat shield outer cover.

    (Refer to Front Seat - "FRONT SEAT OUTER COVER ")

  4. Remove the front seat lower protector (A).
    G12605332Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the protector (A) from the front seat cushion frame.

    [Lower]

    G12605333Courtesy of HYUNDAI MOTOR AMERICA

    [Upper]

    G12605334Courtesy of HYUNDAI MOTOR AMERICA

    [LH]

    G12605335Courtesy of HYUNDAI MOTOR AMERICA

    [RH]

    G12605336Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the front seat cushion cover (A) from the front seat cushion frame.
    G12605337Courtesy of HYUNDAI MOTOR AMERICA
  7. After removing the Velcro tape (A) inside the front seat cushion cover, remove the seat cushion cover (B).
    G12605338Courtesy of HYUNDAI MOTOR AMERICA
  8. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals