Repair Procedures: Removal

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Turn the steering wheel so that the front wheels can face straight ahead.
Remove the driver airbag module.
(Refer to Restraint - "DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING ")
Disconnect the steering wheel connector (A).

Remove the steering wheel lock bolt (B) and then separate the steering wheel from the steering column.

Tightening Torque:

44.1 - 49.0 N.m (4.5 - 5.0 kgf.m, 32.5 - 36.2 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

NOTE:

Do not reuse the steering lock bolt.

When assembling, match the gear teeth as the below image.

Courtesy of HYUNDAI MOTOR AMERICA