Repair Procedures: Removal
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Check the safety after uplift the vehicle with lift.
- Remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
- Disconnect the vacuum pump connector (A).
- Remove the fixing clip and then separate the vacuum hose (A) from the vacuum pump.
- Loosen the mounting bolts and then remove the vacuum pump (A).
Tightening Torque:
19.6 - 29.4 N.m (2.0 - 3.0 kgf.m, 14.4 - 21.6 lb-ft)