Repair Procedures: Removal
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the crash pad lower panel.
(Refer to Body - "CRASH PAD ")
- Disconnect the stop lamp switch connector (A).
- Separate the snap pin (A) and clevis pin (B).
- Remove the brake pedal assembly (A) after loosening the mounting bolts and nuts.
Tightening Torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)