Brake Tube [VDC Control Unit ↔ Master Cylinder]
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the battery negative (-) cable.
- Disconnect the brake fluid level switch connector (A)
- Remove the brake fluid from the master cylinder reservoir with a syringe.NOTE:
- Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
- Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
- Loosen the flare nuts and then separate the brake tube (A) from the master cylinder.
Tightening Torque:
18.6 - 22.6 N.m (1.9 - 2.3 kgf.m. 13.7 - 16.6 lb-ft)
- Separate the intercooler inlet hose (A) from the turbocharger and then remove the inter cooler inlet pipe (B). [Gasoline 1.6 T-GDI]
Tightening Torque
Clamp: 4.9 - 6.9 N.m (0.5 - 0.7 kgf.m, 3.6 - 5.1 lb-ft)
Mounting bolt:
18.6 - 23.5 N.m (1.9 - 2.4kgf.m, 13.7 - 17.4 lb-ft)
- Loosen the flare nuts (A) from the VDC control module (HECU) and remove the brake tube.
Tightening Torque:
18.6 - 22.5 N.m (1.9 - 2.3 kgf.m, 13.7 - 16.6 lb-ft)