Brake Hose
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Disconnect the brake fluid level switch connector (A).
- Remove the brake fluid from the reservoir tank with a syringe after remove the reservoir cap.NOTE:
- Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
- Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
- Remove the front wheel and tire (A) from front hub.
Tightening Torque:
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
NOTE:- Be careful not to damage the hub bolts when removing the wheel and tire (A).
[Front]
[Rear]
- Remove the brake hose clip (A).
- Separate the brake tube after loosening the brake tube flare nut (B).
Tightening Torque:
12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)
[Front]
[Rear]
- Remove the brake hose bracket bolt (A).
Tightening Torque:
8.82 - 13.7 N.m (1.3 - 1.7 kgf.m, 6.5 - 10.1 lb-ft)
- Loosen the brake hose mounting bolt (A) from the caliper and then remove the brake hose.
Tightening Torque:
24.5 - 29.4 N.m (2.5 - 3.0 kgf.m, 18.1 - 21.7 lb-ft)
[Front]
[Rear]