Repair Procedures: Removal
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the air cleaner.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- Remove the battery.
(Refer to Engine Electrical System - "BATTERY ")
- Remove the ECM.
(Refer to Engine Control System - "ENGINE CONTROL MODULE (ECM) (1.6L) or ENGINE CONTROL MODULE (ECM) (2.0L) ")
- Disconnect the brake fluid level switch connector (A).
- Remove the vacuum hose (A) after disconnect fixing clip.
- Remove the master cylinder.
(Refer to Brake System - "MASTER CYLINDER ")
- Remove the snap pin (A) and clevis pin (B).
- Remove the brake booster after loosening the booster mounting nuts (A).
Tightening Torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m 12.3 - 18.8 lb-ft)