Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do Not reuse injector fixing clip.
Do Not reuse the support disc.
Do Not reuse the injector rubber washer.
Do Not reuse the combustion seal.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply engine oil to the injector O-ring.
Do Not reuse injector O-ring.
Do Not reuse bolt.
When inserting the injector, be careful not to damage the injector tip.

Install in the reverse order of removal.
Delivery Pipe Mounting Bolt:

18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)

High Pressure Fuel Pipe Flange Nut:

26.5 - 32.4 N.m (2.7 - 3.3 kgf.m, 19.5 - 23.9 lb-ft)