LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Tire Pressure Monitoring System Diagnosis) >> DTC C1663-00: Auto Location Failure >> Verification Of Repair >> Monitoring DTC Status

Monitoring DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle Parked & Ignition ON.
  2. Connect ScanTool and select "DTC Analysis" mode.
  3. Click "DTC Status" on the "Diagnostic Trouble Codes (DTC)" menu bar to see DTC INFORMATION & INSPECTION .
  4. Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
  5. Read "DTC Status" parameter.
  6. Is parameter displayed "Present Fault"

    YES 

    • Select ECM (PCM) system and Check DTCs related with ECM (PCM) system or CAN Time-Out. If DTC is exist, repair as necessary and then confirm clear.
    • Recheck TPMS system, if C1611-00 is still active DTC, Go to Next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the sensors and/or Control module's connector or was repaired and Control module's memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals