Verification Of Vehicle Repair
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
After a repair, it is essential to verify that the fault has been corrected.
- Connect ScanTool and select "Diagnostic Trouble Codes (DTC)" mode.
- Erase the DTCs and Operate the vehicle within DTC Enable conditions in General information.
- Is any DTC output again?
YES
- Go to the applicable Troubleshooting (DTC INDEX ) procedure.
NO
- System is performing to specification at this time.