Monitoring DTC Status
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Parked & Ignition ON.
- Connect ScanTool and select "DTC Analysis" mode.
- Click "DTC Status" on the "Diagnostic Trouble Codes (DTC)" menu bar to see DTC INFORMATION & INSPECTION .
- Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
- Read "DTC Status" parameter.
- Is parameter displayed "Present Fault"
YES
- In a case that there are any other DTCs except for C1312-00 at self-diagnosing, first repair the problems related to those DTCs and then see if C1312-00 happens again.
- Recheck TPMS system, if C1312-00 is still active DTC, Go to Next procedure.
NO
- This fault was repaired and TPMS Module memory was not cleared. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.