LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Tire Pressure Monitoring System Diagnosis) >> DTC C1312-00: Left Front Sensor Radio Frequency Channel Failure >> DTC Information & Inspection >> Monitor ScanTool Data

Monitor ScanTool Data

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS and select "Data Analysis" mode.
  2. Monitor data of TPMS Sensor parameter on the "Current Data".
  3. After driving at 35 Km/h (22 Mile/h). for approx. 10~20 minutes
  4. Check that current data is correctly displayed while driving.

    Measuring Method:  Refer to No. 1 Measurement

    (Fig.1) A method of checking a sensor ID with VCI

    Check a sensors value out of sensors information.

  5. Park the vehicle on an even ground.
  6. IG "ON".
  7. Set up 'GDS' with 'GDS TPMS'.
  8. Select "Vehicle S/W Management" function.
  9. Select the "Sensor Status" mode of "Data Treatment" part.
  10. Position the GDS TPMS as near as possible to the tire.

    (Reading may take 30~60 seconds depending on the sensors characteristics.)

  11. Check a sensors value out of sensors information.

    Measuring Method:  Refer to No. 2 Measurement

    (Fig.2) A method of checking a sensor ID with GDS TPMS

    Check a sensors value out of sensors information.

    (Fig.2) Data displayed by GDS TPMS (Exciter)

  12. Is the Fig.1's sensor value same with the Fig.2's?

    YES 

    • Fault is intermittent. It has been repaired and TPMS Module memory is not cleared yet.
    • Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • This DTC may be caused by installing other electric devices in the car, except for a genuine part.
    • Find and erase an inside element which can interfere with wireless signals, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • If TPMS Sensor ID is abnormal, register ID and then confirm the sensor ID status.
    • If the pressure of sensor is abnormal, compare values measured by the pressure gauge to the values from GDS.
    • Check the factors which interfere with a radio signal (RF) of the TPMS sensor.
    • Substitute with a known-good TPMS Sensor and check for proper operation.
    • If the problem is corrected, replace Front Left TPMS Sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    • After replacing with a known-good TPMS Sensor, you must do the 'Register Sensor' at the "Vehicle S/W Management  " mode by using GDS and GDS TPMS. and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals