Wire Harness Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Connector(+) | Connector(-) |
|---|---|---|---|---|
| Power circuit (ground short): resistance | Infinite | SMK ECU, Interior Antenna #2 connector: Disconnected Ignition switch: OFF | Interior Antenna #2 power terminal | Chassis ground |
| Power circuit (open): resistance | Approx. below 1 Ω | Interior Antenna #2 power terminal | SMK ECU's Interior Antenna #2 power terminal | |
| Ground circuit (open): resistance | Approx. below 1 Ω | Interior Antenna #2 connector: Disconnected Ignition switch: OFF | Interior Antenna #2 ground terminal | Chassis ground |
- Is the result within specifications?
YES
- Replace the Interior Antenna #2 with an usable test sample and check for proper operation. If it works properly, put the new component in place. Then, go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Inspect the power circuit for an open or short or the ground circuit for an open. Repair relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".