DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Trouble Shooting |
Condition |
Possible Cause |
| Main action |
- Monitor the input signal (CAN Error)
|
- While the driver seat door is open (SMK Unit is not in the Sleep mode)
- check for a short in a CAN High line
- check for a short between CAN High and Low line
- Poor contact of connector.
- Smart key unit (PIC IMMO unit)
NOTE:
Signal level in sleeping mode
- CAN High line: Ground
- CAN Low line: Battery voltage
|
| Prerequisite condition |
- 9V < Battery Voltage < 16V
|
| Threshold value |
- The error count increases by 7 if the CAN Error PIN is low. A DTC sets if the error count reaches 200 or higher (detection period: When a failure persists for 300ms with a 10ms interval, a DTC will appear.)
|
| Diagnosis time |
- DTC persists for over 2 sec.
|
| DTC clearing time |
- DTC will be cleared when the CAN Error PIN returns to the normal state. (Present DTC)
- DTC will be cleared when the CAN Error PIN returns to the normal state and the ignition switch is turned on and off for 30 times. (History DTC)
|