LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 160 (Smart Key Code Saving Diagnosis) >> DTC P1696: Authentication Fail >> DTC Information And Inspection >> Vehicle S/W Management

Vehicle S/W Management

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear DTC after connecting GDS.
  2. If the same DTC returns, check "Smart key state" in "Vehicle S/W Management".
  3. Is the Smart key unit in the 'Learnt' state?

    YES 

    • Fault can be intermittent, caused by poor contact of connectors between the Smart key unit and the ECM. Or, ECM memory was not cleared after repair. Thoroughly check connectors for looseness, poor contact, bending, corrosion, contamination, deterioration, or damage. Repair or replace relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

    • Go to next procedure.
scientia non olet · About LEMON Manuals