ALR (Automatic Locking Retractor) Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | (+) Probe | (-) Probe |
|---|---|---|---|---|
| Open: resistance | Below 0.1 Ω | 1. Ignition switch: OFF 2. ALR sensor connector: Disconnected 3. PODS-G ECU connector: Disconnected |
ALR sensor harness' signal terminal | PODS-G ECU harness' signal terminal |
| ALR sensor harness' ground terminal | PODS-G ECU harness' ground terminal | |||
| Ground short: resistance | Infinite | ALR sensor harness' signal terminal | Chassis ground | |
| ALR sensor harness' ground terminal | ||||
| Power short: voltage | 0V | 1. Ignition switch: ON 2. ALR sensor connector: Disconnected 3. PODS-G ECU connector: Disconnected |
ALR sensor harness' signal terminal | Chassis ground |
| ALR sensor harness' ground terminal |
- Is the result within specifications?
YES
- Go to next procedure.
NO
- Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
- Repair or replace relevant component as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".