LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 158 (Occupant Classification System Diagnosis) >> DTC B1496-54: PODS-G Not Calibration >> Component Inspection >> Notes

Component Inspection: Notes

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch ON & Engine OFF. Using a GDS, clear the DTC.
  2. Turn the ignition switch back OFF.
  3. Disconnect the battery (-) terminal cable from the battery, and wait for at least 1 minute.
  4. Disconnect the PODS-G ECU connector.
  5. Replace the "Seat Cushion ASSY" with an usable one and check for proper operation.
  6. Did the same DTC return?

    YES 

    • Replace the "Seat Cushion ASSY" with the one that completed PODS-G initialization (EOL) properly. Then, conduct "Zero Re- Calibration of Occupant Classification Sensor" and go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

    • Replace the "Seat Cushion ASSY" with a new one. Then, conduct "Zero Re- Calibration of Occupant Classification Sensor" and go to "VERIFICATION OF VEHICLE REPAIR ".
scientia non olet · About LEMON Manuals