DTC Setting Condition

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the data coming from a transponder	Faulty transponder NOTE: DTC also shows up when 2 transponders are stuck close near the Antenna Coil
Threshold Value	Launch the antenna -> IMMO-> sends it to the transponder If the transponder fails to receive the serial number for more than 5 consecutive times, repeat the procedure and set the DTC. Launch the antenna -> IMMO -> sends it to the transponder If the transponder receives 2 serial numbers and values, the data can be duplicate and the IMMO software determines that a transponder is missing. Repeat the procedure for 5 consecutive times and set the DTC.
Diagnosis Time	5 times after turning the ignition switch ON
DTC clearing	Clear the DTC using GDS