Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Plug GDS to Data Link Connector (DLC).
Turn "ON" the ignition switch.
Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
Read the "DTC State" parameter.
Is the DTC State "Present?"

"PRESENT"

Go to the applicable trouble shooting depending on the condition if "Alignment Failure Detail" posts one among "Not aligned/inappropriate termination/horizontal or vertical alignment failure - driving mode".

"HISTORY"

FCA module memory was not cleared after repair. Clear the DTC and go to "VERIFICATION OF VEHICLE REPAIR ".