LOCAL-CAN Communication Line Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| LOCAL-CAN Communication Line: resistance | Infinite |
|
FCA Local- CAN High terminal | Chassis ground |
| FCA Local- CAN Low terminal | Chassis ground | |||
| LOCAL-CAN Communication Line: voltage | Approx. below 5V |
|
FCA Local- CAN High terminal | Chassis ground |
| FCA Local- CAN Low terminal | Chassis ground | |||
| LOCAL-CAN Communication Line: resistance | Approx. below 1Ω |
|
FCA Local- CAN High terminal | LKA-L Local- CAN High terminal |
| FCA Local- CAN Low terminal | LKA-L Local- CAN Low terminal |
- Is the result within specifications?
YES
- This can be an intermittent fault caused by poor contact in the sensor's and/or control module's connector. Or, control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage.
- Repair or replace the relevant component(s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Repair the open/short in the LOCAL-CAN Communication Lines and go to "VERIFICATION OF VEHICLE REPAIR ".