Control Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Voltage | Approx. 2~3V | Ignition SW "ON" | VRC of Sensor Harness | Chassis GND |
| Resistance | Infinite (∞) | Ignition SW "ON" | VRC of Sensor Harness | HO2S Harness |
- Is HO2S display near the specification?
YES
- Go to next step below
NO
- Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
NOTE:
HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire (s). Do not attempt to repair the wire (s), connector, or the terminals.