LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Engine Control System Diagnosis - 2.0L (3 Of 3)) >> DTC P2503-00: AMS No Battery Charge >> Component Inspection >> System Inspection >> Check Generator Circuit

Check Generator Circuit

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine.
  2. Maintain engine speed 2, 500 RPM for 2 minutes.
  3. Measure voltage between the battery terminal (+) and the battery terminal (-).

    Specification:  Approx. 12.5 ~ 14.7V

  4. Is the measured voltage within specification?

    YES 

    NO 

    • Check the tension of the drive belt. Check engine RPM, fuses, terminals of the battery, all terminals of the generator. Check for a damaged harness and poor connections between the generator and battery. If no problems are found repair or replace the generator. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals