GDS Data Analysis

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

With vehicle raised on a lift, start the engine and place transaxle in Drive. Let vehicle idle and verify speedometer indicates approx. 10km/h or more (6 mph or more) on the instrument cluster.
Connect GDS and select ABS/ESP system.
Monitor the "WHEEL SPD SENSOR-FR" parameter on the current data list.
Specification: 10km/h or more (6 mph or more)
Is value within the specification?
YES
- Wheel speed sensor is OK. Go to "SIGNAL CIRCUIT INSPECTION [With ABS]" procedure
NO
- Check for open or short circuit between wheel speed sensor (FR) and ABS/ESP control module
- If problems are found, repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
- If it is okay, check wheel speed sensor (FR) as follows - Gap between wheel speed sensor and trigger wheel (Air gap: 0.3~1.1 mm (0.011 ~ 0.043 in)) - Trigger wheel condition
- Replace wheel speed sensor as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.