LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Engine Control System Diagnosis - 2.0L (3 Of 3)) >> DTC P200A-00: Intake Manifold Runner Performance (Bank 1) >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS to Data Link Connector (DLC) and select "DTC Analysis" mode
  2. Turn "ON" the ignition switch.
  3. Select "Diagnostic Trouble Codes (DTC)", Press "DTC Status" to check DTC information.
  4. Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
  5. Read "DTC Status" parameter.
  6. Record all DTCs, DTC status and freeze frame data. Does DTC Status indicate "Present"?
    NOTE:
    • History (Not Present) state: the DTC set but has been cleared.
    • Present state: the DTC is active at present.

    YES 

    • Go to next procedure.

    NO 

    • This can be an intermittent fault caused by poor contact of the sensor and/or PCM connector. Or, PCM memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace the relevant component (s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".
scientia non olet · About LEMON Manuals