LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Engine Control System Diagnosis - 2.0L (3 Of 3)) >> DTC P0630-00: VIN Not Programmed Or Incompatible - ECM/PCM >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect GDS to Data Link Connector (DLC).
  2. Turn "ON" the ignition switch.
  3. Monitor the PCM status by VIN reading whether it is virgin or Learnt.
  4. Is the PCM status Virgin?

    YES 

    NO 

    • This can be an intermittent fault caused by poor contact of the sensor and/or PCM connector. Or, PCM memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace the relevant component (s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".
scientia non olet · About LEMON Manuals