LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Engine Control System Diagnosis - 2.0L (3 Of 3)) >> DTC P0606-00: ECM/PCM Processor >> Wiring Inspection >> Terminal And Connection Inspection

Terminal And Connection Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the PCM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
  2. Connect the GDS and go to "Current Data".
  3. Monitor PCM values in Current Data, check and wiggle the harness (es), connector (s), and terminal (s).
  4. Any change in the values indicates a poor connection. Was a connector problem found?

    YES 

    NO 

    • Go to next step below
scientia non olet · About LEMON Manuals