Stop Lamp Switch Check
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Check Item | Specifications | Check Condition | Terminal (+) | Terminal (-) |
|---|---|---|---|---|
| Resistance | ∞: Plunger is pushed down 0Ω: Plunger isn't pushed down | Ignition SW "OFF" | Signal terminal of Stop lamp switch connector | Power terminal of Stop lamp switch connector |
| ∞: Plunger isn't pushed down 0Ω: Plunger is pushed down | Signal terminal of Stop switch connector | Power terminal of Stop switch connector |
- Is voltage within specification?
YES
- Check Stop Signal Electronic Module for contamination, deterioration, or damage. Substitute with a known-good switch and check for proper operation. If the problem is corrected, replace Stop Signal Electronic Module and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check Stop Lamp Switch for contamination, deterioration, or damage. Substitute with a known-good switch and check for proper operation. If the problem is corrected, replace switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.