Verification Of Vehicle Repair
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
After a repair, it is essential to verify that the fault has been corrected.
- Connect scantool and select "DTC" button.
- Press "DTC Status" button and confirm that "DTC Readiness Flag" indicates "Completed". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions
- Read "DTC Status" parameter
- Is parameter displayed "History (Not Present)" displayed?
YES
- System performing to specification at this time. Clear the DTC
NO
- Go to the applicable troubleshooting procedure.