LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine Control System Diagnosis - 2.0L (2 Of 3)) >> DTC P0341-00: Camshaft Position Sensor A Circuit Range/Performance (Bank 1) >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear the DTC with GDS.
  2. Operate the vehicle within the following conditions:
    • Engine run time at idle over 10 minutes
    • Engine Oil Temp. is between 20° (68°F) and 110° (230°F)
  3. Ignition switch is turned "ON".
  4. Using a GDS, monitor DTC
  5. Go to applicable troubleshooting procedure for the following conditions
    • If any DTCs related to OCV (P001100) are stored, do ALL REPAIRS associated with those codes before proceeding with this troubleshooting procedure.
    • If DTC P0341-00 is set again, go to next step below
    • If other DTCs are stored, go to the applicable troubleshooting procedure.
    • If no DTC output, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  6. Select "Diagnostic Trouble Codes (DTC)" button, Press "DTC Status" from the DTCs menu.
  7. Confirm that "DTC Readiness Flag" indicates "Complete". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions
  8. Read "DTC Status" parameter
  9. Record all DTCs, DTC status and freeze frame data. Does DTC Status indicate "Present"?
    NOTE: - History (Not Present) fault: DTC occurred but has been cleared.

    YES 

    • Go to next step below.

    NO 

    • Fault is intermittent caused by PCM memory not having been cleared.
scientia non olet · About LEMON Manuals