LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine Control System Diagnosis - 2.0L (2 Of 3)) >> DTC P0340-00: Camshaft Position Sensor 'A' Circuit (Single Sensor) >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
Item  Detecting Condition  Possible Cause 
Case 1 Main Action
  • Check for missing signal
  1. Open or short in signal, ground or power circuit
  2. Poor connection or harness damage
  3. Misadjusted crankshaft and camshaft pulley position
  4. Faulty CMPS #1 (Intake)
Prerequisite Condition
  • First long tooth of CRK passed without failure for DTC P0016-00 and P034100.
Threshold Value
  • No camshaft edge detected within one revolution.
  • # of revolutions without camshaft edge is bigger than 5.
Diagnosis Time
  • 5 Revolutions
Case 2 Main Action
  • Check camshaft edge for out of range
Prerequisite Condition
  • First long tooth of CRK passed or first camshaft edge passed
Threshold Value
  • # of revolutions with Camshaft edge is over 6 before synchronization.
Diagnosis Time
  • 6 Revolutions
MIL-On Condition
  • 2nd Driving Cycle
scientia non olet · About LEMON Manuals