LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine Control System Diagnosis - 2.0L (2 Of 3)) >> DTC P0304-00: Cylinder 4 - Misfire Detected >> Component Inspection >> System Inspection >> Visual Inspection

Visual Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Visually/physically inspect for the following conditions
    • Vacuum hoses in engine room for splits, kinks and improper installation
    • Positive crankcase ventilation valve for improper installation, damaged o-rings and malfunctioning.
    • Verify that the PCM ground connections are clean and properly tightened.
  2. Check MAFS and ECTS for the following conditions:
    • Contamination, deterioration, poor connection or damaged harness
    • The MAF signal displayed on the GDS should increase as engine speed increases
    • The engine coolant temperature displayed on the GDS should close to the actual coolant temperature.
  3. Was a problem found in any of the above areas?

    YES 

    NO 

    • Go to next step below