LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Engine Control System Diagnosis - 2.0L (1 Of 3)) >> DTC P0106-00: Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance >> DTC Information And Inspection >> DTC Detecting Condition

DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
Item Detecting Condition Possible Cause
Case 1 Main Action
  • Plausibility check
  1. Dirty air cleaner
  2. Oil Cap or Dipstick missing or not installed correctly.
  3. Air leakage in intake system
  4. Contact resistance in connectors
  5. Faulty MAPS or TPS
Prerequisite Condition
  • Engine speed during engine start is higher than 640 to 960 RPM.
  • Battery voltage is between 11V and 16V.
  • Pressure quotient (Manifold pressure/BARO) is smaller than 0.8.
Threshold Value
  • Filtered and reduced area controller of Intake manifold (model) versus ambient pressure and throttle opening area is between 40~90% and -90~-40%.
Case 2 Main Action
  • Plausibility check
Prerequisite Condition
  • Engine speed during engine starting is higher than 640 to 960 RPM.
  • Battery voltage is between 11V and 16V.
  • Pressure quotient (Manifold pressure/BARO) is bigger than 0.8.
Threshold Value
  • Filtered BARO controller of Intake manifold (model) versus ambient pressure is between 20~30% and -30~-20%.
Diagnostic Time
  • 5 Seconds
MIL-On Condition
  • 3rd Driving Cycle
scientia non olet · About LEMON Manuals