LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Engine Control System Diagnosis - 2.0L (1 Of 3)) >> DTC P0014-00: 'B' Camshaft Position - Timing Over-Advanced Or System Performance (Bank 1) >> Wiring Inspection >> Terminal And Connector Inspection

Terminal And Connector Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the OCV and PCM connectors and inspect for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Reconnect the connectors.
  2. Connect the GDS and go to "Current Data".
  3. Monitor camshaft actual position in Current Data, check and wiggle the harness (es), connector (s), and terminal (s).
  4. Any change in the values indicates a poor connection. Was a connector problem found?

    YES 

    NO 

scientia non olet · About LEMON Manuals