Circuit Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.

Item	Normal Value	Prerequisite Condition	(+) Probe	(-) Probe
Signal Circuit: Voltage (Short to battery) CAN HIGH Circuit CAN LOW Circuit	Approx. 0V	Ignition switch: ON CAN communication module connector: Disconnected	CAN HIGH Terminal CAN LOW Terminal (DLC harness connector)	Chassis ground
Signal Circuit: Resistance (Short to ground) CAN HIGH Circuit CAN LOW Circuit	Infinite	Ignition switch: ON CAN communication module connector: Disconnected	CAN HIGH Terminal CAN LOW Terminal (DLC harness connector)	Chassis ground
Signal Circuit: Resistance (Open) CAN HIGH Circuit CAN LOW Circuit	Approx. below 1Ω	Ignition switch: ON CAN communication module connector: Disconnected	CAN HIGH Terminal (DLC harness connector)	CAN HIGH Terminal (Each module.)
	Approx. below 1Ω		CAN LOW Terminal (DLC harness connector)	CAN LOW Terminal (Each module.)

Is the result within specifications?
YES
- Go to next step below.
NO
- Repair relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".