LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (Engine Control System Diagnosis - 1.6L (3 Of 3)) >> DTC P2127-00: Throttle/Pedal Position Sensor/Switch 'E' Circuit Low Input >> Component Inspection >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch "OFF" and install a GDS.
  2. Warm up the engine to normal operating temperature.
  3. Monitor "APS" parameter on the "Current Data" with GDS.

    Specification:  "Current Data" will be displayed as follows.

  4. Is the measured Current Data OK?

    YES 

    • Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

    • Replace the APS with an usable one and check for proper operation. If the problem is corrected, replace the APS and then go to "VERIFICATION OF VEHICLE REPAIR ".
scientia non olet · About LEMON Manuals